alu alu blister packing machine The packaging machine adopts the internal heating roller contact heating method, uses PVC hard sheets and DPT aluminum foil as packaging materials, and is in the form of plate blister. It is suitable for small pharmaceutical factories, hospital preparation departments, health care product companies, and pharmaceutical factory research institutes. Ideal equipment to use
Blister Packaging Machine How to operate
1. Process flow for alu blister machine
The process flow of the Blister Packaging Machine is to first heat the plastic film and suck it into a blister, then fill the blister with medicine, heat-press and seal the blister with aluminum foil, and finally punch it into plates of the specified size.
2. Operating procedures of alu blister machine
01. Turn on the power switch of the alu blister machine and open the cooling water supply valve.
02. Press the preheat switch, turn on the heater switch of alu blister machine, and turn on the machine to preheat the bubble flow mold to 30 degrees.
03. Place the PVC hard sheet on to Flat Plate Blister Packaging Machine, slightly past the foam roller mold.
04. Close alu alu packing machine bubble heater box, heated PVC hard sheet
05. Press the main motor start switch for Blister Packaging Machine. After soaking the PVC for 4 meters, press the main motor stop switch and open the hot box.
06. Load the bubble tape into each station of the alu blister machine, slightly past the stepping roller, and enter the plexiglass guide plate on the die.
07. When the temperature of the Flat Plate Blister Packaging Machine temperature controller displays around 150 degrees, lay out the aluminum foil, open the feeder gate, and press the heater motor switch.
Close the hot box of the bubble heater, press the feeder switch, press the main motor start switch, close the anilox roller, and the machine starts to work fully
Post time: Mar-20-2024
