Vacuum Mixer Homogenizer ·operating procedures (most common procedure )
1. Check and confirm that the Vacuum Mixer Homogenizer status is marked as "Intact Equipment".
2. Check whether the switches and valves of Vacuum Mixer Homogenizer are in their original positions.
3. Check whether the rotating parts such as the homogenizing part, stirring paddle, and scraper are safe, reliable and firm.
Check whether Vacuum Mixer Homogenizer the power supply voltage, meter, indication, etc. are normal.
Before the operation,Vacuum Homogenizer Mixer is necessary to feed the material, and the stirring slurry needs to be opened while heating.
Vacuum Homogenizer Mixer can be turned on and stirred at the same time when there is enough material in the pot. The stirring speed needs to be adjusted upwards from zero to the desired speed.
If the homogenizer is found to be faulty during operation, turn off the power quickly and disassemble it for maintenance.
When opening the vacuum system of Vacuum Homogenizer Mixer , first open the vacuum control switch, and then open the vacuum line valve. When closing, first close the vacuum pipeline valve, then turn off the power supply, when the negative pressure is 0.05mpa to 0.06mpa, open the feed valve to inhale the material. The vacuum degree in the emulsifying pot should not be too high, generally kept between 0.05mpa and 0.06mpa, so as not to cause the water to boil.
The work buckle of Vacuum Homogenizer Mixer must be guarded by a special person, and the person leaves the machine to stop.
Turn the speed to zero before stopping. Press the stirring stop button again.
Turn off the power switch of Vacuum Homogenizer Mixer , check whether each water valve is closed, and open the vacuum exhaust valve.
After discharging the semi-finished product, wash the residue in the pot with warm water to keep the pot clean
Maintenance and maintenance procedures for Vacuum Emulsifying Mixer
1. Vacuum Emulsifying Mixer is maintained once a year.
2. Check the lubricated and tightened parts of the motor and pump that are prone to loosening.
3. Check all electrical components of Vacuum Emulsifying Mixer
4. Check whether the sealing ring of Vacuum Emulsifying Mixer is in good condition.
Cleaning procedures for Vacuum Emulsifying Mixer
1. Conditions and frequency of cleaning: Wipe the equipment before production and clean it after production.
2. Cleaning location: The host is cleaned in place.
3. Scope of cleaning: mainframe and components.
4. Cleaning agent: drinking water, purified water.
5. Cleaning tools: cloth, mercerized towel, bucket.
6. The removal of the last batch of status identification cards: dismantled and discarded (tear up).
7. Cleaning method: After the production is over, first cut off the power supply of the equipment. Remove residue from equipment. Wipe the surface of the equipment with a cloth dipped in drinking water until it is clean, and then use a mercerized towel dipped in purified water to clean the surface of the equipment again. The tank is cleaned with drinking water and then cleaned again with purified water.
8. Cleaning effect: No dirt and no oil stains after cleaning. After passing the QA inspection, hang the "Cleaned" status mark and fill in the validity period.
9. Storage of cleaning tools: Wash the used cleaning tools with drinking water and store them in the sanitary ware room.
10. Precautions: Before cleaning, cut off the power supply of the equipment, and wring it out when scrubbing the electrical panel of the equipment with a cloth to prevent water from entering the inside of the electrical appliance.
Smart Zhitong has many years of experience in the development, design and production of Vacuum Homogenizing Emulsifier Machine， Vacuum Emulsifying Mixer Machine and the machine capacity from 5L to 18000L also Vacuum Emulsifying Mixer Machine Vacuum Emulsifier Machine for loading system
If you have concerns please contact
Post time: Oct-28-2022
