Some common problems of Tube Fill Machine (excluding the problems caused by the low quality of the filling and sealing machine itself) are analyzed. First of all, before analyzing the specific problems that arise, the equipment must be tested as follows:
●Check whether the actual running speed of the + filling and sealing machine is the same as the initial debugging speed of this specification;
●Detect whether the LEISTER heater of Plastic Tube Filler Sealer is in the open position;
●Detect whether the compressed air supply pressure of plastic tube filling and sealing machine the meets the pressure requirements when the equipment is working normally;
●Check whether the cooling water circulates smoothly, and whether the temperature of the cooling water is within the range required by the Plastic Tube Filler
●Check whether there is ointment dripping in the filling and sealing machine, especially to ensure that the material does not stick to the upper part of the inner and outer walls of the tube;
●Do not contact the inner surface of the tube with anything to avoid contamination of the inner and outer walls of the hose;
●Detect whether the air intake of the LEISTER heater is normal
● Check whether the temperature detector inside the heater is in the correct position
●Check whether the heating head exhaust device of Tube Fill Machine is working normally. After the above initial inspection, let’s analyze some common specific problems of ++filling and sealing machines: Phenomenon 1: The phenomenon on the left
1. is usually caused by excessive temperature. At this time, it should be checked whether the actual temperature is the temperature required for the normal operation of the Tube Fill Machine The actual temperature on the temperature display should be relatively stable with the set temperature (the normal deviation range is between 1°C and 3°C).
Phenomenon 2: There are ears on one side as shown in the figure below: first check whether the heating head is correctly placed in the heating head nest; then check the verticality of the heating head and the hose below. Another possible reason for the phenomenon of ears on one side is the deviation of the parallelism of the two tail clips. The deviation of the parallelism of the tail clamp can be detected by a spacer between 0.2 and 0.3 mm (the detection method is shown in the illustration on the left)
Phenomenon 3: The end seal starts to crack from the middle of the hose. This phenomenon means that the size of the heating head is not enough. Please replace it with a larger heating head. The standard for judging the size of the heating head is to insert the heating head into the hose, and then pull it out, and feel a slight suction when pulling it out.
Phenomenon 4: "eye bags" appear under the explosion-proof line of the seal: the appearance of this situation is that the height of the air outlet of the heating head is wrong, and it can be adjusted in the following way.
Phenomenon 5: The middle of the tail of the hose is sunken: This problem is usually due to the wrong size of the tube cup.
1.Smart Zhitong has many years of experience in the development, design plastic tube filling and sealing machine
If you have concerns please contact
@carlos
Wechat WhatsApp +86 158 00 211 936
For more tube filler machine type . please visit the website https://www.cosmeticagitator.com/tubes-filling-machine/
Post time: Nov-30-2022
