cosmetic tube filling sealing machine correct operating procedures
1. Check whether all components are intact and firm, whether the power supply voltage is normal, and whether the gas circuit is normal.
2. Check whether the sensors such as pipe seat chain, cup seat, cam, switch and color mark are in good condition and reliable.
3. Check whether the connection and lubrication of each mechanical part are in good condition.
4. Check whether the tube loading station, tube crimping station, light alignment station, filling station, and sealing station are coordinated.
5. Clear tools and other objects around the equipment.
6. Check whether all parts of Automatic Tube Sealing Machine the feeding unit are intact and firm.
7. Check whether the control switch is in the original position, and turn the ointment tube filling and sealing machine with the hand wheel to determine whether there is any fault.
8. After confirming that the previous process is normal, turn on the power supply and the air valve, jog the machine for trial operation, first run at low speed, and gradually increase to normal speed after it is normal.
9. The upper pipe station adjusts the speed of the upper pipe motor to match the speed of the electric rod puller with the speed of the machine to maintain automatic pipe drop operation.
10. The tube pressing station drives the pressure head to run at the same time through the up and down reciprocating movement of the cam linkage mechanism, and presses the tube to the correct position.
11. Use the hand wheel to move the car to the light position, turn the light cam to make the light cam close to the switch, and make the light beam of the photoelectric switch irradiate the center of the color mark, with a distance of 5-10 mm.
12. The filling station is that when the hose is lifted at the light-facing station, the probe tube proximity switch on the top of the tube jacks up the cone end to switch on the signal through the PLC and then through the solenoid valve to make it work, and it is 20MM away from the end of the hose. When the filling injection paste is over.
13. To adjust the filling volume, loosen the nuts first, then turn the respective screw rods and move the position of the stroke arm slider, increase outwards, otherwise adjust inwards, and finally lock the nuts.
14. The sealing station adjusts the upper and lower positions of the sealing knife holder according to the needs of the pipe, and the gap between the sealing knives is about 0.2MM.
15. Turn on the power and air source, start the automatic operation system, and the filling and sealing machine enters automatic operation.
16. It is strictly forbidden for non-maintenance operators to adjust the setting parameters arbitrarily. If the setting is incorrect, the unit may not work normally, and the unit may be damaged in severe cases. If it is necessary to adjust during the application process, please do it when the unit stops running.
17. It is strictly forbidden to adjust the unit when the unit is running.
18. Stop pressing the "Stop" button, and then turn off the power switch and air source switch.
19. Thoroughly clean the feeding unit and filling and sealing machine unit.
20. Keep records of equipment operation status and routine maintenance.
Smart Zhitong has many years of experience in the development, design Automatic Tube Filler and Sealer
Please visit website for more details: https://www.cosmeticagitator.com/tubes-filling-machine/
If you have concerns please contact
Post time: Jan-12-2023
